This page shows you the procedure to get a new registration code for
version 2.6 of Q-Recovery if you currently have a version 2.0 code.
(For instructions on how to proceed if you have a version 1.x code,
click here)
- As a registered customer of any previous version of
Q-Recovery, you should already have received your new registration
code for version 2.6 by e-mail. Simply enter the new code in the setup
program or in Q-Recovery 2000.
- If you don't received our e-mail but have already a
version 2.0 code, simply enter the 2.0 code in the setup
program when installing Q-Recovery 2000. The installation program
will show you then your new version 2.6 code. Write it down for later
use!
If you run into problems, please contact customer
service.
